With the adapter cable HIGO-S3-B2-AK you can connect a 2-pole brake switch to a 3-pole controller, e.g. the Magura MT5e to the Bafang BBS mid-motor.
The HIGO-S3-B2-AK adapter cable is available in lengths from 150 mm to 2000 mm.
The connection of the two individual cables is made by soldering, and is referred to as knot (KNot, or just KN). With an extension cable, 1 cable goes in - KNot - 1 cable goes out, so it's a 1-KN-1 connection.
When ordering a standard extension cable (the node is in the middle of the compound, that is, L1 = L2) you only need to specify the total length L required in the field Notes and special requests at the checkout.
Example: a HIGO-S3-B2-AK adapter cable with a required total length of e.g. 1260mm then is a HIGO-S3-B2-AK-1260. Both parts of the adaptor cable would then be 630 mm long.
Should the knot NOT be located centrally on the eadaptor cable, specify the individual lengths in the field Notes and special requests at the checkout.
Example: For a HIGO-S3-B2-AK adapter cable with a total length L = 1260 mm, the knot should be 300 mm from the end of HIGO-S3 connector (the male connector).
This extension cable is then referred to as HIGO-S3-B2-AK-1260-S3-300.
Connections made with our extension cables are dust- and waterproof to IP67 and can be bend even at the knot with a radius of 32 mm (about 1 1/4").
As an alternative we can offer you the HIGO-S3-B2-A adaptor with an overall lenght of only 50mm